RFC 7405: Case-Sensitive String Support in ABNF
[RFC Home] [TEXT|PDF|HTML] [Tracker] [IPR] [Errata] [Info page]
PROPOSED STANDARD
Errata ExistInternet Engineering Task Force (IETF) P. Kyzivat
Request for Comments: 7405 December 2014
Updates: 5234
Category: Standards Track
ISSN: 2070-1721
Case-Sensitive String Support in ABNF
Abstract
This document extends the base definition of ABNF (Augmented Backus-
Naur Form) to include a way to specify US-ASCII string literals that
are matched in a case-sensitive manner.
Status of This Memo
This is an Internet Standards Track document.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Further information on
Internet Standards is available in Section 2 of RFC 5741.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
http://www.rfc-editor.org/info/rfc7405.
Copyright Notice
Copyright (c) 2014 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Kyzivat Standards Track [Page 1]
RFC 7405 Case-Sensitive String Support in ABNF December 2014
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Updates to RFC 5234 . . . . . . . . . . . . . . . . . . . . . 2
2.1. Terminal Values - Literal Text Strings . . . . . . . . . 3
2.2. ABNF Definition of ABNF - char-val . . . . . . . . . . . 4
3. Security Considerations . . . . . . . . . . . . . . . . . . . 4
4. Normative References . . . . . . . . . . . . . . . . . . . . 4
Author's Address . . . . . . . . . . . . . . . . . . . . . . . . 4
1. Introduction
The base definition of ABNF (Augmented Backus-Naur Form) supports US-
ASCII string literals. The matching of these literals is done in a
case-insensitive manner. While this is often the desired behavior,
in some situations, case-sensitive matching of string literals is
needed. Literals for case-sensitive matching must be specified using
the numeric representation of those characters, which is inconvenient
and error prone both to write and read.
This document extends ABNF to have two different types of US-ASCII
string literals. One type is matched using case-sensitive matching,
while the other is matched using case-insensitive matching. These
types are denoted using type prefixes similar to the type prefixes
used with numeric values. If no prefix is used, then case-
insensitive matching is used (as is consistent with previous
behavior).
This document is structured as a set of changes to the full ABNF
specification [RFC5234].
2. Updates to RFC 5234
This document makes changes to two parts of [RFC5234]. The two
changes are as follows:
o Replace the last half of Section 2.3 of [RFC5234] (beginning with
"ABNF permits the specification of literal text strings") with the
contents of Section 2.1.
o Replace the <char-val> rule in Section 4 of [RFC5234] with the
contents of Section 2.2.
Kyzivat Standards Track [Page 2]
RFC 7405 Case-Sensitive String Support in ABNF December 2014
2.1. Terminal Values - Literal Text Strings
ABNF permits the specification of literal text strings directly,
enclosed in quotation marks. Hence:
command = "command string"
Literal text strings are interpreted as a concatenated set of
printable characters.
NOTE:
The character set for these strings is US-ASCII.
Literal text strings in ABNF may be either case sensitive or case
insensitive. The form of matching used with a literal text string is
denoted by a prefix to the quoted string. The following prefixes are
allowed:
%s = case-sensitive
%i = case-insensitive
To be consistent with prior implementations of ABNF, having no prefix
means that the string is case insensitive and is equivalent to having
the "%i" prefix.
Hence:
rulename = %i"aBc"
and:
rulename = "abc"
will both match "abc", "Abc", "aBc", "abC", "ABc", "aBC", "AbC", and
"ABC".
In contrast:
rulename = %s"aBc"
will match only "aBc" and will not match "abc", "Abc", "abC", "ABc",
"aBC", "AbC", or "ABC".
In the past, the numerical specification of individual characters was
used to define a case-sensitive rule.
Kyzivat Standards Track [Page 3]
RFC 7405 Case-Sensitive String Support in ABNF December 2014
For example:
rulename = %d97 %d98 %d99
or
rulename = %x61.62.63
will match only the string that comprises only the lowercase
characters, abc. Using a literal text string with a prefix has a
clear readability advantage over the old way.
2.2. ABNF Definition of ABNF - char-val
char-val = case-insensitive-string /
case-sensitive-string
case-insensitive-string =
[ "%i" ] quoted-string
case-sensitive-string =
"%s" quoted-string
quoted-string = DQUOTE *(%x20-21 / %x23-7E) DQUOTE
; quoted string of SP and VCHAR
; without DQUOTE
3. Security Considerations
Security is truly believed to be irrelevant to this document.
4. Normative References
[RFC5234] Crocker, D. and P. Overell, "Augmented BNF for Syntax
Specifications: ABNF", STD 68, RFC 5234, January 2008,
<http:/www.rfc-editor.org/info/rfc5234>.
Author's Address
Paul Kyzivat
Massachusetts
United States
EMail: pkyzivat@alum.mit.edu
Kyzivat Standards Track [Page 4]