Abstract
In this paper, a new method of actuator fault detection and isolation in output feedback is proposed in the multiple-input multiple-output feedback system. Under the feedback control, fault source can be covered and make the fault isolation difficult. To address such an issue, the fault space is firstly segmented and the fault feature is extracted according to the space geometry theory. By this approach, the residual generator can be constructed. Secondly, in allusion to the coupling between residuals and disturbances in the feedback system, a sufficient and necessary condition for decoupling is given. Then a threshold is set to detect the fault exists or not, and the structured residual set is built to realize the relationship between residuals and faults. Consequently, the fault isolation can be achieved. Simulation results validate the feasibility and validity of the proposed algorithm.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Zhou, D.H., Ye, Y.Z.: Model-Based Fault Diagnosis and Fault Tolerant Control. Tsinghua University Press, Beijing (2000)
Zhou, D.H., Shi, J.T., He, X.: Review of intermittent fault diagnosis techniques for dynamic systems. Acta Automatica Sinica 40(2), 161–171 (2014)
Hu, J., Wen, C., Li, P., et al.: Direct projection to latent variable space for fault detection. J. Frankl. Inst. 351(3), 1226–1250 (2014)
Wen, C.L., Lv, F.Y., Bao, Z.J., et al.: A review of data driven-based incipient fault diagnosis. Acta Automatica Sinica 42(9), 1285–1299 (2016)
Zhou, D.H., Liu, Y., He, X.: Review on fault diagnosis techniques for closed-loop systems. Acta Automatica Sinica 39(11), 1933–1943 (2013)
Raimondo, D.M., Marseglia, G.R., Braatz, R.D., et al.: Closed-loop input design for guaranteed fault diagnosis using set-valued observers. Automatica 74, 107–117 (2016)
Cheng, Y., Wang, R., Xu, M.: A combined model-based and intelligent method for small fault detection and isolation of actuators. IEEE Trans. Ind. Electron. 63(4), 2403–2413 (2016)
McNabb, C.A., Qin, S.J.: Fault diagnosis in the feedback-invariant subspace of closed-loop systems. Ind. Eng. Chem. Res. 44(8), 2359–2368 (2005)
Wang, K., Chen, J., Song, Z.: Data-driven sensor fault diagnosis systems for linear feedback control loops. J. Process Control 54, 152–171 (2017)
Yang, G.H., Wang, H.: Fault detection and isolation for a class of uncertain state-feedback fuzzy control systems. IEEE Trans. Fuzzy Syst. 23(1), 139–151 (2015)
Zhai, S., Wang, W., Ye, H.: Fault diagnosis based on parameter estimation in closed-loop systems. IET Control Theory Appl. 9(7), 1146–1153 (2015)
Shen, B., Ding, F., Alsaedi, A., et al.: Gradient-based recursive identification methods for input nonlinear equation error closed-loop systems. Circ. Syst. Signal Process. 36(5), 2166–2183 (2017)
Zhao, Q.J., Jiang, B.: A novel method of model-based fault detection for closed-loop systems. Control Eng. China. 2(12), 174–176 (2005)
Basile, G., Marro, G.: Controlled and Conditioned Invariants in Linear System Theory. Prentice Hall, Englewood Cliffs (1992)
Basile, G., Marro, G.: Controlled and conditioned invariant subspaces in linear system theory. J. Optim. Theory Appl. 3(5), 306–315 (1969)
Massoumnia, M.A.: A geometric approach to the synthesis of failure detection filters. IEEE Trans. Autom. Control 31(9), 839–846 (1986)
Acknowledgements
The authors acknowledge the National Natural Science Foundation of China (Grant: 61374134), the Henan Natural Science Foundation (Grant: 162300410030).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hou, Y., Huang, R., Cheng, Q. et al. Fault detection and isolation for output feedback system based on space geometry method. Cluster Comput 22 (Suppl 4), 9313–9321 (2019). https://doi.org/10.1007/s10586-018-2143-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10586-018-2143-x