Abstract
Nowadays, the integration of MEMS accelerometer in vibration measurement system such as a condition-based monitoring (CBM) become necessary as it is tiny, low in weight, power consumption and cost. The MPU9250 is one of the cheapest accelerometers that capable to measure large movements and low frequencies. It also has lower noise level and consumes less energy compared to MPU6050. The DLPF enables MPU9250 to be configure by selecting the suitable noise filtration. In this study, an experiment is conducted to validate the MPU9250 accelerometer measurement with the embedded MEMS accelerometer of smart mobile device. The vibration at the end of motorcycle’s handlebar is measured and the result shows that the used DLPF filtering enable the MPU9250 to achieve an equal result as embedded MEMS accelerometer of smart mobile device.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Guru Manikandan K, Pannirselvam K, Kenned JJ, Suresh Kumar C (2021) Investigation on suitability of MEMS based accelerometer for vibration measurements. Mater Today Proc 45:6183–6192
Tjhai C, O'Keefe K (2019) Using step size and lower limb segment orientation from multiple low-cost wearable inertial/magnetic sensors for Pedestrian navigation. Sensors 19:3140
Hayouni M, Vuong T-H, Choubani F (2022) Wireless IoT universal approach based on Allan variance method for detection of artificial vibration signatures of a DC motor's shaft and reconstruction of the reference signal. IET Wirel Sens Syst 12:81–92
Mark L (2014) An introduction to MEMS vibration monitoring. Analog Dialogue 48(6):1–3
Komarizadehasl S, Mobaraki B, Ma H, Lozano-Galant JA, Turmo J (2021) Development of a low-cost system for the accurate measurement of structural vibrations. Sensors 21:6191
MPU-9250 Product Specification Revision 1.1: InvenSense Inc. Indianapolis, CA 95110 U.S.A. (2016)
Usamah NM, Mazlan AZA, Ripin ZM (2022) Investigation of motorcycle handle vibration attenuation using a suspended handlebar with different rubber mount characteristics. Int J Acoust Vibr 27(3):276–284
Acknowledgements
The authors would like to thank the Ministry of Higher Education Malaysia for Fundamental Research Grant Scheme (FRGS) with Project Code: FRGS/1/2021/TK0/USM/03/6.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2024 The Author(s), under exclusive license to Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Rosli, M.A.M., Manap, A.H.A., Mazlan, A.Z.A. (2024). A Low-Cost Vibration Measurement Using MEMS MPU9250 Accelerometer with DLPF Filtering. In: Ahmad, N.S., Mohamad-Saleh, J., Teh, J. (eds) Proceedings of the 12th International Conference on Robotics, Vision, Signal Processing and Power Applications. RoViSP 2021. Lecture Notes in Electrical Engineering, vol 1123. Springer, Singapore. https://doi.org/10.1007/978-981-99-9005-4_50
Download citation
DOI: https://doi.org/10.1007/978-981-99-9005-4_50
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-99-9004-7
Online ISBN: 978-981-99-9005-4
eBook Packages: Intelligent Technologies and RoboticsIntelligent Technologies and Robotics (R0)