由于IPSEC ×××不能支持组播和广播,因此不能运行动态路由协议,由于我们需要把一条×××链路作为一条专线使用,还必须建立GRE tunnel隧道,以支持动态路由协议.
实验拓扑:
GRE over IPSEC ××× _“网络
基本配置步骤如下:
1:配置基本路由和需保护流量的感兴趣访问列表(注意这里感兴趣流量设为GRE隧道流量)
2:配置GRE Tunnel隧道.
3:配置IPSEC ×××.
4 :配置动态路由协议.
配置如下 :
R1#sho run
crypto isakmp policy 10
authentication pre-share
crypto isakmp key cisco address 202.1.1.2
!
crypto ipsec transform-set mytrans esp-3des
!
crypto map mymap 1 ipsec-isakmp
set peer 202.1.1.2
set transform-set mytrans
match address 101
!
interface Loopback0
ip address 10.1.1.1 255.255.255.0
!
interface Tunnel0
ip address 192.168.1.1 255.255.255.0
tunnel source Ethernet0/0
tunnel destination 202.1.1.2
!
interface Ethernet0/0
ip address 201.1.1.1 255.255.255.0
crypto map mymap
router ospf 1
log-adjacency-changes
network 10.1.1.0 0.0.0.255 area 0
network 192.168.1.0 0.0.0.255 area 0
ip route 0.0.0.0 0.0.0.0 Ethernet0/0

access-list 101 permit gre host 201.1.1.1 host 202.1.1.2
//注意访问列表所定义的IPSEC所保护的感兴趣流量为GRE流量.
R2#
interface Ethernet0/0
ip address 201.1.1.2 255.255.255.0
!
interface Ethernet2/0
ip address 202.1.1.1 255.255.255.0

R3#
crypto isakmp policy 10
authentication pre-share
crypto isakmp key cisco address 201.1.1.1
!
!
crypto ipsec transform-set mytrans esp-3des
!
crypto map mymap 10 ipsec-isakmp
set peer 201.1.1.1
set transform-set mytrans
match address 101
!
interface Loopback0
ip address 172.16.1.1 255.255.255.0
!
interface Tunnel0
ip address 192.168.1.2 255.255.255.0
tunnel source Ethernet2/0
tunnel destination 201.1.1.1
!
interface Ethernet2/0
ip address 202.1.1.2 255.255.255.0
half-duplex
crypto map mymap
!
router ospf 1
log-adjacency-changes
network 172.16.1.0 0.0.0.255 area 0
network 192.168.1.0 0.0.0.255 area 0
ip route 0.0.0.0 0.0.0.0 Ethernet2/0
!
access-list 101 permit gre host 202.1.1.2 host 201.1.1.1
测试:
R1#show ip os nei
Neighbor ID     Pri   State           Dead Time   Address         Interface
172.16.1.1        0   FULL/ -        00:00:37    192.168.1.2     Tunnel0
R1#show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2
       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
       ia - IS-IS inter area, * - candidate default, U - per-user static route
       o - ODR, P - periodic downloaded static route
Gateway of last resort is 0.0.0.0 to network 0.0.0.0
C    201.1.1.0/24 is directly connected, Ethernet0/0
     172.16.0.0/32 is subnetted, 1 subnets
O       172.16.1.1 [110/11112] via 192.168.1.2, 00:41:22, Tunnel0
     10.0.0.0/24 is subnetted, 1 subnets
C       10.1.1.0 is directly connected, Loopback0
C    192.168.1.0/24 is directly connected, Tunnel0
S*   0.0.0.0/0 is directly connected, Ethernet0/0
R1#show crypto isakmp sa
dst             src             state          conn-id slot
202.1.1.2       201.1.1.1       QM_IDLE              8    0
R1#traceroute 172.16.1.1
Type escape sequence to abort.
Tracing the route to 172.16.1.1