Flexural rigidity of microtubules and actin filaments measured from thermal fluctuations in shape - PubMed Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 1993 Feb;120(4):923-34.
doi: 10.1083/jcb.120.4.923.

Flexural rigidity of microtubules and actin filaments measured from thermal fluctuations in shape

F Gittes  1 , B Mickey, J Nettleton, J Howard
Affiliations

Flexural rigidity of microtubules and actin filaments measured from thermal fluctuations in shape

F Gittes et al. J Cell Biol. 1993 Feb.

Abstract

Microtubules are long, proteinaceous filaments that perform structural functions in eukaryotic cells by defining cellular shape and serving as tracks for intracellular motor proteins. We report the first accurate measurements of the flexural rigidity of microtubules. By analyzing the thermally driven fluctuations in their shape, we estimated the mean flexural rigidity of taxol-stabilized microtubules to be 2.2 x 10(-23) Nm2 (with 6.4% uncertainty) for seven unlabeled microtubules and 2.1 x 10(-23) Nm2 (with 4.7% uncertainty) for eight rhodamine-labeled microtubules. These values are similar to earlier, less precise estimates of microtubule bending stiffness obtained by modeling flagellar motion. A similar analysis on seven rhodamine-phalloidin-labeled actin filaments gave a flexural rigidity of 7.3 x 10(-26) Nm2 (with 6% uncertainty), consistent with previously reported results. The flexural rigidity of these microtubules corresponds to a persistence length of 5,200 microns showing that a microtubule is rigid over cellular dimensions. By contrast, the persistence length of an actin filament is only approximately 17.7 microns, perhaps explaining why actin filaments within cells are usually cross-linked into bundles. The greater flexural rigidity of a microtubule compared to an actin filament mainly derives from the former's larger cross-section. If tubulin were homogeneous and isotropic, then the microtubule's Young's modulus would be approximately 1.2 GPa, similar to Plexiglas and rigid plastics. Microtubules are expected to be almost inextensible: the compliance of cells is due primarily to filament bending or sliding between filaments rather than the stretching of the filaments themselves.

PubMed Disclaimer

Similar articles

See all similar articles

Cited by

See all "Cited by" articles

References

    1. J Exp Biol. 1966 Aug;45(1):113-39 - PubMed
    1. Biol Cell. 1991;71(1-2):161-74 - PubMed
    1. Biochemistry. 1974 Dec 31;13(27):5529-37 - PubMed
    1. Soc Gen Physiol Ser. 1975;30:165-79 - PubMed
    1. J Mol Biol. 1980 Jan 15;136(2):169-82 - PubMed

Publication types